About this role
Job Title: UDV / HW Design Verification Engineer
Location: Dallas, Texas, USA (On-site)
Experience: 5–8 Years
Preferred Qualification: Bachelors or Masters in Electronics / Electrical / RF Engineering or related field
Job Description:
We are looking for an experienced UDV / HW Design Verification Engineer to work on-site at the Dallas R&D Lab. You will plan and run hardware verification on units, find and analyze issues, and report results to the engineering teams.
Key Responsibilities:
- Create the verification plan from product and design requirements
- Define test scope, test cases, test methods and acceptance criteria
- Set up the test environment and operate measurement equipment
- Perform unit bring-up and functional verification
- Verify RF and electrical performance, including operating and corner conditions
- Analyze results, run regression tests, isolate faults and find root causes
- Report defects in and verify corrective actions
- Prepare verification reports and release readiness evidence; support factory if needed
- Maintain requirement-to-test traceability and test coverage
Required Skills & Experience:
- Hands-on experience in hardware / unit design verification
- Strong knowledge of RF and electrical measurements and lab instruments
- Experience in test planning, test case design and test automation
- Skilled in debugging, fault isolation and root-cause analysis
- Experience with verification reports and defect tracking
- Experience with Python or similar scripting for test automation
- Knowledge of PA / RF radio hardware
- Good communication and documentation skills
Work Location & Travel:
- Dallas R&D Lab – on-site presence required for lab and design work.