Inspector, Detail I

Determines and documents the modification status/configuration of products being processed for repair or overhaul to verify compliance to the applicable regulatory and customer requirements.

• Ensures the products to be inspected are sufficiently clean and in acceptable condition to perform the inspections necessary to complete the work instruction.

• Determines the repairability of those products not meeting the applicable requirements.

• Records the inspection results on the appropriate inspection documentation.

• Generates an estimate on the cost of replacement parts and labour necessary to complete the applicable work instructions.

• Generates the applicable documentation for the repair of unserviceable products.

• Inspects and identifies parts in the Reduced to Spares (RTS) process.

• Supervises detail inspection trainees in the on-the-job training (OJT) process.

• Participates in continuous improvement of cell processes.

• Cross trains in other complementary skills and seeks endorsements for those skills as needed to support production requirements.

• Moves between production assignments that utilize multiple skills as needed to support production requirements.

• Participates in the cross training of other technicians as needed to support production requirements.

• Responsible for observing all applicable safety requirements and reporting immediately any unsafe practices/conditions.

• Carries out other duties as assigned.

Relocation Provided: No

Position Requirements: Knowledgeable and proficient in the proper use of precision measuring equipment.

• Ability to read, understand and interpret blueprints.

• Knowledgeable in and ability to identify and interpret conditions on products that are the result of service operation.

• Ability to use and interpret publications used in the production process (graphs, charts, schematics, blueprints).

• Working knowledge of the functions and operation of the products being inspected.

• Proficient in technical writing.

• Working knowledge of production management computer system and other related internal control systems.

• Ability to complete the Detail Inspector Training & Development Plan.

• Ability to lift up to 50 pounds (unassisted) for approximately 25% of the average work day.

• Regularly required to sit for prolonged periods.

• Previous inspection experience preferred.

Job grade will be dependent on qualifications!